Caution messages – Sony VPL-VW100 User Manual
Page 62
GB
62
Troubleshooting
Caution messages
Please replace the Lamp/
Filter.
End of Lamp/Filter life.
Lamp off in 1 min.
c It is time to replace the lamp. Replace the lamp. (1 page 63)
c Also, replace the air filter too. (1 page 67)
If this message appears again after you replace the lamp and filter,
the lamp replacement process is not complete. Check the lamp
replacement process. (
Please clean the filter.
c It is time to clean the air filter. Clean the air filter. (1 page 66)
Please clean the filter. Have
you finished? Yes
V No v
c It is time to clean the air filter. Clean the air filter. (1 page 66)
c If you cleaned the air filter, select “Yes.” If you did not clean the
air filter, select “No.”
Probably use in high
altitude. Switch to high
altitude mode on? Yes
V
No
v
c When using the projector at an altitude of 1,500 m or higher:
select “Yes” to set to “High Altitude Mode”. (
c If this message is displayed when using the projector at an
altitude of less than 1,500 m: check to see if nothing is blocking
the ventilation holes. (
Note
When you selected “Yes,” the number of turns of the fan increases.
Message
Cause and Remedy
c No signal is input in the selected input. Check connections. (1
Not applicable!
c Press the appropriate button.
Please check Network
Setting.
c Invalid values, such as a blank, are entered in the
Network Setting window. Enter the correct values. (
x