Sony VPL-VW100 User Manual
Page 52
GB
52
Installation Menu
Network Setting
You can set internet protocols such as IP address, Subnet Mask, Default
Gateway, and DNS Server when accessing the projector from a computer or
using “ImageDirector2” application supplied.
After completing all of settings, select “Apply” using
m button, then press
ENTER.
To use the Network setting function,
set “Standby Mode” to “Standard” in the
Function
High Altitude Mode
Use this item when using the projector at high altitudes.
Off: Use this setting when using the projector at normal altitudes.
On: Use this setting when using the projector at an altitude of 1,500
m or higher.
Note
When this item is set to “On,” the number of turns of the fan
increases.
IP Address Setup
Selects either “Auto (DHCP)” or “Manual.”
When you select “Manual,” set the following “IP Address,”
“Subnet Mask,” and “Default Gateway.”
IP Address
Sets the IP Address of the projector.
(1.0.0.0 to 223.255.255.255)
Subnet Mask
Sets the Subnet Mask of the projector.
(1.0.0.0 to 255.255.255.255)
Default Gateway
Sets the Default Gateway of the projector.
(1.0.0.0 to 223.255.255.255)
Primary DNS
Sets the DNS server to be used as a priority.
(1.0.0.0 to 223.255.255.255)
Secondry DNS
Sets the alternative DNS server.
(1.0.0.0 to 223.255.255.255)
MAC Address
Displays MAC address of the projector. You cannot change.
Note