ATEN ATEN Matrix KVM KM0832 - Manual (Page 49)

Chapter 4. Administrator Utility
39
2. Follow the instructions on page 118 of this user manual to manually set the
IP address or to view the current settings. (If DHCP is enabled, you will
not be able to view the IP address.)
To assign an IP address from the command line:
1. Power off the KM0832.
2. At the command line, enter the following command:
arp -s
is an IP address suitable for the network segment that the
KM0832 resides on.
is the MAC address found on the bottom panel of the
KM0832.
3. Power on the KM0832.
4. Within 30 seconds of powering on the KM0832, enter the following
command at the command line:
ping
is the IP address that you entered in Step 2.
If you receive a reply, then the KM0832 accepted the IP address. You may
now follow the procedure to login (see page 40).