Audiovox RVMPKG4 - Manual (Page 6)

d). Trim off excess length of the straps.
e). Place (hide) the monitor cable behind the windshield trim piece down under
the dash area.
(2) Wiring the Monitor
a) RED FUSED WIRE: 12VDC ACCESSORY SOURCE
Connect this wire to a source that has 12 volts when the Ignition key switch is
turned on, and 0 volts when the Ignition key switch is turned off.
b) BLACK WIRE: CHASSIS GROUND
Connect this wire to a solid, metal part of the vehicle’s chassis.
c) PINK WIRE: GROUND WHEN PARKING BRAKE IS APPLIED
Connect this wire to the wire from the parking brake that turns on the parking
brake light on the dash, this wire will have ground when the parking brake is
pressed.
(3) Connect the mirror cable and power cable as shown in Figure 6
on page 10.
2. Signal Inputs
The signal input connections for the system include:
(1) Rear Camera: Connect the yellow & white RCA connectors to the same
color RCA plug on the extension cable. Run the extension cable to the
control box and connect the yellow & white RCA connectors on the
extension cable to the RCA plugs on the control box. Connect the control
box cable to the rearview mirror cable as shown in figure 6, on page 10.
(2) Audio/Video Input Plugs: RCA are located at the end of the control box.
By connecting video and audio signals with these plugs. The user can watch
the auxiliary video input only when the parking brake is engaged.
5