ATEN CS-88A - Manual (Page 21)

M Auto Scanning
Auto Scan automatically switches among all the active CPU Ports that are
accessible to the currently logged on User at regular intervals (see Scan
Mode of the OSD F3 SET function, p. 26), so that he can monitor their activity
automatically.
Setting the Scan Interval:
The amount of time Auto Scan dwells on each port is set with the Scan
Duration setting of the OSD F3 SET function (see p. 26). You can change the
scan interval before activating Hotkey Auto Scanning, if you wish, with the
following Hotkey combination:
1. Invoke Hotkey Mode (see p. 15)
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 1-255 that represents
the number of seconds for the dwell time.
The letter T, and the numbers display on the Command Line as you key
them in. If you make a mistake, use [Backspace] to erase the wrong
number.
3. Press [Enter]
After you press [Enter], you automatically exit Hotkey Mode, and are ready
to start Auto Scanning.
2002-12-27
CS-88A User Manual 17