Asus K8N - Manual (Page 52)

2-18 Chapter 2: BIOS Setup
DRAM RAS PRECHANGE Time [Auto]
Sets the DRAM RAS PRECHANGE Time.
Configuration options: [Auto] [2 CLK] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
DRAM ACTIVE TIME [Auto]
Sets the DRAM ACTIVE TIME. Configuration options: [Auto] [5 CLK] [6 CLK]
[7 CLK] [8 CLK] [9 CLK] [10 CLK] [11 CLK] [12 CLK] [13 CLK] [14 CLK] [15 CLK]
1T/2T Timing [Auto]
Sets the DRAM command timing. When set to Auto, the DRAM timing is set to 2T if
the CPU installed can support 2T timing. Configuration options: [1T] [Auto]
Master ECC Enable [Disabled]
Enables or disables support on all nodes for ECC error detect and correction.
Configuration options: [Disabled] [Enabled]
Audio CODEC Interface [Auto]
Allows you to set the onboard audio CODEC interface. [Auto] allows the BIOS to
detect whether you are using any audio device.
Configuration options: [Enabled] [Disabled] [Auto]
Primary Video [PCI]
Switches the PCI Bus scanning order while searching for a video card. This allows
you to select the type of Primary VGA in case of multiple video controllers.
Configuration options: [PCI] [AGP]
Aperture Size [ 128 MB]
Allows you to select the size of mapped memory for AGP graphic data.
Configuration options: [32 MB] [64 MB] [128 MB] [256 MB] [512 MB]
AGP FW Enable [Auto]
Disables or sets to automatic the AGP Fast Write feature.
Configuration options: [Auto] [Disabled]
AGP Sideband Address [Auto]
Disables or sets to automatic the AGP Sideband address.
Configuration options: [Auto] [Disabled]