Karcher K 2-350 - Manual (Page 10)

10 English
 STEP 5:
Disconnect the garden hose from the
water inlet on the unit.
 STEP 6:
Disconnect the high pressure hose
from the high pressure outlet.
1 Disconnect all water connections.
2 Turn on the machine for a few sec-
onds, until the water which had re-
mained in the pump exits, turn off
immediately.
3 Do not allow high pressure hose to
become kinked.
4 Store the machine and accessories in
a room which does not reach freezing
temperatures. DO NOT store near
furnace or other sources of heat as it
may dry out the pump seals.
ṇ CAUTION
Failure to follow the above directions will
result in damage to the pump assembly
and accessories and will void the war-
ranty.
Kärcher
® also recommends the regular
practice of using a pump protector like
“Kärcher
® Pump Guard” to prevent cold
weather damage during storage in the
winter months.
 STEP 1:
Disconect the connector from the
water inlet.
 STEP 2:
Pull out water inlet filter with flat-nose
pliers.
 STEP 3:
Rinse out water inlet filter in warm
water.
 STEP 4:
Reinsert water inlet filter into the wa-
ter inlet.
The unit is maintenance-free.
ṇ
CAUTION
 Before cleaning any surface an in-
conspicuous area should be cleaned
to test spray pattern and distance for
maximum cleaning results.
 If painted surfaces are peeling or
chipping, use extreme caution as
pressure washer may remove the
loose paint from the surface.
WINTERIZING AND LONG-
TERM STORAGE
CARE AND MAINTENANCE
INSTRUCTIONS
Cleaning the water inlet filter
Maintenance
CLEANING TIPS