Karcher HD 2-5-27 P - Manual (Page 8)

8.780-013.0 • Xpert-HD • Rev. 10/12
OPERA
T
OR’S MANU
AL
PRESSURE W
ASHER
8
STEP 1: Attach the handle to the
frame of the pressure washer. Note:
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports. STEP 2: Insert the carriage bolt
through the holes from the back of
the unit and attach a knob from the
front of the machine. Tighten Knobs
with by hand. STEP 3: Attach the Gun & hose
hanger and insert nuts from inside.
Tighten nuts.
STEP 5: Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
STEP 8: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly. STEP 9: Connect the high pres-
sure hose to the discharge nipple.
Push coupler collar forward until
secure.
STEP 6: Attach wand to spray gun.
Tighten wand.
STEP 7: Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
STEP 10: Connect garden hose to
the cold water source.
ASSEMBLY INSTRUCTIONS
STEP 11: Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
Frame
Assy.
Bolt
Knob
Gun &
Hose
Hanger
Safety
Latch
Spray
Gun
High
Pressure Hose
Wand
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
Nut
STEP 4: Attach the plastic plate
from the top aligned to the four
holes placed on top of the handle
and insert the rivets through holes
of plastic plate.
Rivets
Plastic
Plate