beautypg.com

Troubleshooting, Pressure w asher t roub leshooting guide – Karcher HD 2-5-27 P User Manual

Page 14

background image

8.780-013.0 • Xpert-HD • Rev. 10/12

PRESSURE

W

ASHER

T

roub

leshooting Guide

14

PROBLEM

POSSIBLE CAUSE

SOLUTION

ENGINE OPERATES
FOR 15 MINUTES
THEN STOPS

Not enough gas or engine oil

Fill tank with gas. Check oil level.

Vapor lock developed by heat of day

Keep gas tank full to avoid vapor locking.

Obstruction in fuel fi lter

Clean or replace fuel fi lter.

ENGINE LACKS
POWER

Dirty air fi lter

Replace air fi lter.

ENGINE FALTERS

Choke is opened too soon

Move choke to halfway position until engine
runs smoothly.

WATER DRIPPING
FROM UNDER PUMP

Piston packing worn

Call local distributor.

O-Ring plunger retainer worn

Call local distributor.

Cracked piston

Call local distributor.

OIL DRIPPING

Oil seal worn or damaged

Call local distributor.

WATER LEAKING
FROM PUMP
PROTECTOR

Spray gun closed with machine
running 5 minutes or longer

Open spray gun or turn off machine.

Excess water supply pressure

Place a pressure regulator at end of 50'
garden hose.

NO DETERGENT

Detergent suction tube not properly
connected to machine

Check connection.

Detergent is too thick

Dilute detergent. For best results, use
manufacturers detergent.

Detergent fi lter valve is at lowest
setting

Set detergent fi lter valve to a higher setting.

Filter on detergent suction tube is
clogged

Run warm water through fi lter to remove
debris.

Damaged or clogged detergent suc-
tion tube

Remove obstruction or replace detergent
suction tube.

A high pressure nozzle is attached.

Replace with black detergent nozzle.

Discharge nozzle is obstructed

Blow out or remove debris with fi ne needle.

GARDEN HOSE
CONNECTION
LEAKS

Loose fi ttings

Tighten fi ttings.

Missing/worn rubber washer

Insert new washer.

SPRAY WAND
LEAKS

Spray wand not properly attached

Slide the spray wand into the gun. Turn the
wand collar clockwise onto the spray gun
threads until tight.

Broken o-ring

Call local distributor and order an o-ring.

PUMP IS NOISY

Pump is sucking air

Check that hoses and fi ttings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady fl ow of
water emerges through nozzle.

TROUBLESHOOTING