Transport storage maintenance and care – Karcher Hartbodenreiniger BR 4-300 User Manual
Page 14

– 4
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
Î
Swivel the appliance handle forward
and arrest in the park position.
Î
Swivel the pushing handle backwards
and push the appliance.
or
Î
Lift appliance by the carrying handle
and carry it.
Î
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
ƽ
Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
Caution
Risk of damage to the appliance on ac-
count of water leakage. Empty the waste
water reservoir and the fresh water reser-
voir prior to performing maintenance on the
appliance.
Caution
Risk of damage. Do not wash down the ap-
pliance with water and do not use aggres-
sive detergents.
Î
Empty the dirt water reservoir.
Î
Clean the seals between the waste wa-
ter reservoir and the appliance.
Î
Empty the fresh water reservoir.
Î
Rinse the appliance: Fill the fresh water
reservoir with clear water (without de-
tergent) and let the appliance run for
one minute with the brush water supply
turned on.
Î
Empty the fresh water reservoir.
Î
Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
Î
Clean the vacuum bar, check for wear
and replace if required (see "Mainte-
nance tasks").
Î
Check the brush for wear and replace if
required (see "Maintenance tasks").
Note
The vacuum bars are attached to the appli-
ance with snaps and can simply be pulled
off.
Î
Remove the fresh water reservoir.
Î
Remove the dirt water reservoir.
Î
Lay the device on the reverse.
Î
Pull off the vacuum bar downwards.
Î
Insert the new vacuum bars and lock
them into place.
Î
Remove the fresh water reservoir.
Î
Remove the dirt water reservoir.
Î
Lay the device on the reverse.
Î
Press the release button for the brush
roller and swivel the brush roller toward
the bottom and pull it off the driver.
Î
Place the new brush roller on the driver
and lock into place on the opposite side.
In case of danger of frost:
Î
Empty the fresh and dirt water reser-
voirs.
Î
Store the appliance in a frost-protected
room.
Transport
Storage
Maintenance and care
Maintenance schedule
After the work
Maintenance Works
Replace the vacuum bar.
Replacing the brush roller
Frost protection
14
EN