Karcher SensorTimer TM ST6 DUO eco!ogic - Manual (Page 26)

– 10
Selecting / changing sensor
 If a setting is to be changed after initial startup, the relevant sensor must be selected
first. This step is a precondition for all further settings.
 Switch into the settings mode using the esc/menu
button.
Sensor 1 is flashing.
 Press the arrow key in order to select between sen-
sor 1 and sensor 2.
 Confirm with the OK button.
 The settings for the selected sensor can now be
made.
esc
menu
Ok
Time-controlled watering - not sensor-controlled
 When teaching the sensor, push the esc/menu
button within the 60-second countdown to activate
the time-controlled watering of the relevant valve
outlet.
 Then continue with the entry of the watering time
and watering duration.
See operating instructions.
Note
The watering automatically takes place at the preset watering times. ECO delay days are
considered.
Important: If watering is to take place in a sensor-controlled way again, you need to restart
with teaching the sensors by a RESET of the device.
esc
menu
26 EN