Karcher NT 75-1 Tact Me Te H - Manual (Page 22)

– 5
ṇ
Warning
The flat pleated filter must always be in
place while vacuuming.
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle, or if water is
sucked up from a container, it is recom-
mended to deactivate the "automatic fil-
ter cleaning" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After the wet vacuuming: Clean the flat
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
 Plug in the main plug.
 Switch on the appliance at the rotating
knob.
 Set the suction output (min - max) at the
rotary switch.
ƽ
Danger
Risk of injury and damage! The socket out-
let is only for the connection of power tools
to the vacuum cleaner. Any other use of the
socket outlet is not permitted.

Connect the mains plug of the electric
power tool to the vacuum cleaner.
 Switch on the appliance at the rotating
knob.
Indicator lamp is on; vacuum cleaner is in
the standby mode.
Note: The vacuum cleaner is turned on and
off automatically with the electric power
tool.
Note: The vacuum cleaner starts automat-
ically within 0.5 seconds and continues to
run for 15 seconds after the power tool has
being switched off.
Note: Please refer to "Technical specifica-
tions" for the power connection specifica-
tions of the power tools.
Illustration

Adjust the stepped power tool adaptor
to fit the connection of the electric pow-
er tool.
Illustration

Remove the elbow from the suction
hose.
 Attach the stepped power tool adaptor
to the suction hose.
Illustration

Connect the adaptor to the electric pow-
er tool.
Note: The different suction hose sections
are required to allow an adjustment to the
connection sections of the processing
tools.

Set the minimum volume flow for the
suction hose cross section at the rotary
switch.
The scale displays the suction hose cross
section.
General
Clip connection
Operation
Rotating knob
– Appliance ON
– Filter dedusting OFF
– Appliance OFF
– Appliance ON
– Filter dedusting ON
Turning on the Appliance
Adjust the suction output
Working with electrical power tools
22 EN