Karcher NT 75-1 Tact Me Te H - Manual (Page 21)

– 4
– The appliance is equipped with a paper
filter bag fitted with locking lid.
Order No. Safety filter sack: 6.904-
420.0 (5 pieces)
Note: You can use this appliance to take up
all types of dust up to dust class H. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values.
– Unused flat-fold filters may only be
stored and transported in the packaging
(carton).
Illustration
– The lamella of the flat-fold filter should
not be touched during installation.
ṇ
Warning
The flat-fold filter and the safety filter sack
must never be removed during the dust ex-
traction process.
 Release and remove the suction head.
Illustration

Insert the safety filter sack.
Illustration

Place the safety filter bag over the con-
tainer and insert the interior paper filter
bag into the container in an L-shaped
fashion.
 Insert and lock the suction head.
ƽ
Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
Illustration

Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Illustration

Properly insert the connection socket in
the suction connection.
 Push in the connection socket until it
locks into place.
 Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
 Release and remove the suction head.
Illustration

Pull over the safety filter sack.
Illustration

Pull out the safety sheet.
 Close the safety filter sack using the
self-adhesive flap.
 Pull the safety filter bag down and back-
wards from the filter nozzle.
Illustration

Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
Illustration

Securely close the safety filter bag with
the attached cable tie.
 Remove the safety filter bag.
 Wipe the inside of the container using a
damp cloth.
 Dispose of the safety filter bag in a dust-
tight bag according to the statutory pro-
visions.
 Insert and lock the suction head.
– To suck wet dirt, always remove the
safety filter bag.
Dry vacuum cleaning
Installing the safety filter sack
Wet vacuum cleaning
Inserting the rubber lips
Close the suction connection
Removing the safety filter sack
21 EN