Karcher Sensore pioggia - Manual (Page 11)

English 11
Illustrations on Page 4
Î Use a coin to open the cover for the rain sensor on the irrigation
device.
Î Remove the cable bridge and attach in the housing according to
the irrigation device model.
Note: If the irrigation device is used without a rain sensor, the ca-
ble bridge must be reconnected, as the irrigation device will not
function otherwise!
WU 60/49
Î Guide the rain sensor cable through the cover of the irrigation de-
vice.
Î Connect the rain sensor cable and lock the connector into the
latches.
Î Close cover.
WU 90/72
Î Guide the rain sensor cable through the cover of the irrigation de-
vice.
Î Carefully break out the preperforated cable opening on the cover.
Î Close cover.
The rain sensor will interrupt the programme run of the connected ir-
rigation device depending on the amount of precipitation. The collect-
ed water evaporates and thus simulates the water use in the ground.
If the fluid level falls below the setpoint, the programme run is once
again activated.
Start up
Operation