Karcher HD 1050 De Cage - Manual (Page 19)

– 4
Follow the instructions given in the sec-
tion "Safety Notes"!

Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
 Fill the fuel tank with the required fuel
(see technical data).
Do not use 2-speed mixture.
 Check oil level of the engine.
Do not operate the appliance if the oil level
has fallen below "MIN".

If required, top up oil carefully.
 Connect high pressure hose and spray
pipe to the hand spray gun.
 Install the nozzle on the spray pipe in
such a way that the marking is on the
top.
 Tighten covering nut firmly.
 Connect the high pressure hose to the
high pressure connection point of the
machine.
– For connection values refer to technical
specifications
– Observe regulations of water supplier.
According to DIN 1988 it is not allowed
to connect the device directly to the
public water supply. A brief connection
through a pipe interruptor (Order Nr.
6.412-578) is admissible. The high
pressure cleaner is to be separated
from the water supply after use.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4“) to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
 Open the water supply.
Note
The supply hose is not included.
ƽ
Danger
Never suck in water from a drinking water
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil
or unfiltered water. The sealings within the
device are not solvent resistant. The spray
mist of solvents is highly inflammable, ex-
plosive and poisonous.

Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the
water connection point.
 Set the pressure and quantity regula-
tion to "MAX" (not with HD 801 B Cage).
 Set dosing value for detergent to "0".
 Remove air from appliance before oper-
ation.
 Open the water supply.
 Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
 To dearate the appliance, unscrew the noz-
zle and allow the appliance to run until the
water exits in a bubble-free state.
 Switch off the appliance and fit the noz-
zle again.
ƽ
Danger
– Place the appliance on firm surface.
– The high pressure cleaner must not be
used by children. (Risk of accident on
account of improper use of the appli-
ance).
– The high pressure spray generates high
levels of noise when the appliance is in
use. Risk of hearing impairment. Al-
ways use proper ear-protection aids
while working with the appliance.
– The water jet coming out of the high
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can
cause additional torque. Hence hold the
spray pipe and gun firmly.
Motor
Install hand spray gun
Water connection
Suck in water from vessel
Dearating the appliance
Operation
19 EN