Karcher SV 1902 - Manual (Page 21)

– 11
 Extension (E1): This is an accessory
that can be used for optimal cleaning of
areas that are very difficult to access.
Ideal for cleaning room heaters, door-
posts, windows, rolling shutter, sanitary
units.
The use of hand-suction nozzle is used for
glass and mirror surfaces, smooth surfaces
in general or for cleaning fabric areas such
as sofas, mattresses, etc.
The hand nozzle can be combined with the
following accessories. As shown in Figure
D, the accessories are attached to the hand
nozzle. The upper sides of the detachable
lips are marked as "Upper Part".

Small detachable lip (F1): For smaller
surfaces such as muntin windows and
mirrors.
 Large detachable lip (F2): For window
panes and larger surfaces such as wall
tiles.
 Crown brush (F3): For carpets, stair-
cases, car interiors, fabric surfaces in
general (after carrying out a test at a
hidden area).
A terry towel cover (F4) can also be put
on the brush.
Cleaning windows
Use the following procedure to use the ma-
chine properly for cleaning windows:

To loosen the dirt, apply steam uniform-
ly on the surface to be treated.
 Press the detachable lip against the
surface to be cleaned and move it from
the top to the bottom and keep the vac-
uum cleaning function on.
ƽ
Caution!
In seasons when the temperatures are par-
ticularly low, pre-heat the window panes by
letting out steam from a distance of approx.
50 cm from the surface to be cleaned.
Round brush kit (order No. 2.860-231) 4
round brushes for the detail nozzle.
HEPA Filter (Order No.. 2.860-229)
ṇ
DANGER
Always disconnect the mains plug and al-
low the machine to cool down before per-
forming any maintenance work.
Allow the accessory parts to dry completely
before storing them.

Do not place the brushes onto the bris-
tles during the cooling and drying proc-
ess to avoid a deformation of the
bristles.
 Use a moist cloth for cleaning the ma-
chine from the outside. Avoid using any
solutions or cleaning agents as they
can damage the plastic surfacce.
 Follow the instructions in the section ""
for cleaning the water filter container
and for cleaning or replacing the foam
filter (21).
 Check the washers in the steam plug
(B1) at regular intervals. Replace them
if necessary. Carry out the same
checks for the connecting washers of
the steam suction pipe (C) and the han-
dle (A).
The machine is equipped with a HEPA filter
(15) that you can clean under flowing water.
Proceed as follows to clean the filter.

Remove the water filter container (17) ac-
cording to the instructions in the chapter
"Filling the water filter container".
 Lift the unhooking lever (16) of the HEPA fil-
ter and remove the filter from its position
(Fig. 12).
 Rinse the HEPA filter under cold flowing
water. Shake the HEPA filter carefully
after cleaning so that any residual dirt or
excess water is removed.
Steam suction - hand nozzle (F)
Special accessories
Maintenance and care
Care
Maintenance
HEPA filter
21 EN