Ferguson Ariva 200 - Manual (Page 54)

none of the buttons function (i.e. the search was not be stopped at the correct time) or the majority of the buttons do not
function correctly, restart the search (see steps 3 to 4) to find a suitable code. If the majority of the buttons function correctly,
set up has been successful. Re-press the TV button to save the code and to terminate the set-up mode.
N O T E : Entering the auto searching mode, it will search forward from the current code.
N O T E : After all codes have been gone through, The POWER button will flash three times and go off. The RCU640 exit
from auto search automatically.
S e t u p T V vi a br a nd n a m e c o d e
1.Switch on the TV for which you wish to use the remote control.
2.Find the code number of your TV brand in the code list (e.g. LG 0009; 0051; 0059; …).
3.Press T V button for three seconds The POWER button on your remote control lights up, i.e. RCU640 is in set-up mode.
4.Enter the 4-digit device code (e.g. 0051 for LG TV set). If an entry does not occur within 10 seconds, the set-up mode is
automatically terminated.
5.The POWER button LED goes out if the remote control accepts the code.
If the POWER button LED flashes three times the code is incorrect; and you need to start from step 2.
If this occurs, re-enter the correct code from the list.
6.Check the function of the buttons on your remote control. If the majority of the buttons on your new remote control do
not function correctly, enter another 4-digit device code (e.g. 0059…) from the list under the same brand name. Repeat
steps 3 to 6 until all the basic functions operate correctly. The TV is set up correctly as soon as you enter the correct
code.
N O T E : Exit the set-up mode by pressing the TV button or OK button. The set-up mode is automatically terminated if a
button is not pressed during a 10 second period.
S e t u p T V vi a m a nu al s e a r c h
1.Switch on the TV for which you wish to use the remote control.
2.Point the remote control at the TV. Press and hold down the T V button for three seconds. Then release the button.
3.The POWER button lights up and the remote control is in set-up mode.
4.Press the VO L+ button approx. every 1.5 seconds. The device should start to flash, i.e. the device is in Manual Search
mode.
5.As soon as the TV volume changes, press TV button to save the codes and exit from Manual Search mode, now the
POWER button light goes off.
6.Check whether the other buttons on the remote control function correctly. If the majority of the buttons do not function
54