A.J. Antunes & Co HDC-50A 9300360 - Manual (Page 13)

Hot Dog Corral
13
A.J. Antunes & Co.
P/N 1010609 Rev. I 03/12
trOublesHOOtInG
warnInG
to avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equip-
ment should be performed by qualified service personnel. the unit should be unplugged when servicing.
problem possible Cause Corrective action
unit will not heat up.
Rocket switch (Power
On/Off) is ON.
Power cord not plugged in. Plug Power cord into the appropriate outlet.
circuit breaker is off or has been tripped
in the main power supply.
turn on or reset the circuit breaker.
thermostats not turned on. turn the thermostats to the proper settings.
Loose connections. check the continuity of the wiring. tighten as
needed.
Defective wiring. Replace the defective wires.
Defective Power cord. check Power cord continuity. Replace if
necessary.
Defective Rocker switch (Power On/Off). If there is power to the switch in the ON posi-
tion but no power coming out, replace the
switch.
Defective thermostat. Replace thermostat.
Defective Heating element(s). Replace Heating element(s).
the Drive frame does
not move smoothly.
Drive frame out of square. Repair or replace Driver frame.
black Driver Rollers or Nylon glides are
missing or need lubrication.
Install new Driver Rollers and/or Nylon glides
or lubricate with a small amount of food grade
grease.
Drive mechanism bent or damaged. Replace bent or damaged components.
Improper drive alignment. see “Inspecting and aligning Drive Parts” in
the Maintenance section of this manual.
Defective Motor. Repair or replace Motor.
the Driver frame does
not move but unit gets
hot.
Loose, damaged, or worn drive
component(s) or loose setscrew(s).
Locate component(s) in question and refasten
or replace. tighten setscrew(s).
Defective Motor. Replace Motor.
Insulation has detached and stalled the
Motor fan blade.
Remove base Plate and reposition the
Insulation under the Insulation Retainer.
the Drive frame
scratches the grill
surface or side panels.
Driver frame is out of square, bent, or
damaged.
Repair or replace Driver frame.
Nylon glides are missing or worn. Replace Nylon glides according to the
Maintenance section of this manual.
the Drive frame
climbs over the product
continuously or inter-
mittently.
One or more of the Driver frame Roller
Rods are tight and do not roll freely, or
do not have side to side play.
soak the Driver frame in hot, soapy water for
one hour. Perform the Daily cleaning accord-
ing to the Maintenance section of this manual.
If the rods are still tight, use a mallet to hit the
frame outwards and away from the tight rod(s)
to free the rods up. If the rods are still tight,
replace the Driver frame.
Product is under or
over cooked.
Improper thermostat setting(s). Re-adjust thermostat(s).
Defective thermostat(s). Replace thermostat(s).