A.J. Antunes & Co HDC-50A 9300360 - Manual (Page 11)

Hot Dog Corral
11
A.J. Antunes & Co.
P/N 1010609 Rev. I 03/12
INCORRECT
Remove Gap
Straight Edge
CORRECT
No Gap
Straight Edge
figure 5. aligning Drive Components
figure 4. Drive Components
left side Cover
Driver roller
slide bracket
with pins
Driver frame w/ roller rods
right side Cover
motor arm
w/ setscrew
retaining ring pivot arm w/setscrew
motor arm
& pivot arm
Connecting
link
Driver
roller
maIntenanCe (continued)
Cross-
over
shaft
motor
shaft
pivot
arm
motor arm
motor arm
& pivot arm
Connecting link
replacing the black nylon Glides
the black Nylon glides allow the Driver frame to slide
back and forth smoothly and also prevents it from
scratching the grill surface area.
Depending on the model, the glides are attached to the
Driver frame or to the unit itself (see figure 6 and 6a).
the glides eventually wear down with normal use
and will require replacement as needed.
nOte: failure to replace missing/worn glides will
result in permanent Grill surface and Driver frame
Damage, nOt covered by warranty.
HDC-21a/35a Only: Remove the four Retainer Rings
and glides (figure 6). Install new glides and secure with
Retainer Rings.
HDC-20/30a/50a Only: using a small screwdriver, pry
the four glides up and out of the unit (figure 6a). Push
the new glides into the unit.
figure 6. HDC-21a/35a Only
figure 6a. HDC-20/30a/50a Only
nylon Glides (4)
retainer ring
& nylon Glide
(HDC-21a/35a
Only)
Inner
wall