beautypg.com

Nikon D7000 User Manual

Page 145

background image

125

r

5

Check the results.

If the camera was able to measure a value for white
balance,

C will flash in the control panel for about

six seconds, while the viewfinder will show a flashing
a.

If lighting is too dark or too bright, the camera may be
unable to measure white balance. A flashing

b a

will appear in the control panel and viewfinder for
about six seconds. Press the shutter-release button
halfway to return to Step 4 and measure white balance
again.

6

Select preset d-0.

If the new value for preset white balance will be used immediately, select preset
d-0 by pressing the WB button and rotating the sub-command dial until d-0 is
displayed in the control panel.

D

Direct Measurement Mode

If no operations are performed while the displays are flashing, direct measurement mode
will end in the time selected for Custom Setting c2 (Auto meter-off delay,

0 214).

A

Preset d-0

The new value for white balance will be stored in preset d-0,
automatically replacing the previous value for this preset (no
confirmation dialog will be displayed). A thumbnail will be
displayed in the preset white balance list (

0 126).

To use the new value for white balance, select preset d-0 (if no value has been measured for
white balance before d-0 is selected, white balance will be set to a color temperature of
5,200 K, the same as Direct sunlight). The new white balance value will remain in preset d-
0 until white balance is measured again. By copying preset d-0 to one of the other presets
before measuring a new value for white balance, up to five white balance values can be
stored (

0 126).

Control panel

Viewfinder

Control panel

Viewfinder