Acer 310 - Manual (Page 118)

Frequently-Asked Questions
98 User’s Guide
The keyboard does not respond.
Try attaching an external keyboard to the PS/2 connector
on the computer’s rear. If it works, contact your dealer or
an authorized service center as the internal keyboard cable
may be loose.
The serial mouse does not work.
❑ Make sure that the serial cable is plugged securely into
the serial port.
❑ During POST, press F2 to access the Setup Utility. Go to
the Advanced screen and verify that the serial port is
enabled and has no conflicts with other serial devices
(IrDA). See “Advanced” on page 86 for details.
The printer does not work.
❑ Make sure that the printer is connected to a power
outlet and it is turned on.
❑ Make sure the printer cable is connected securely to the
computer’s parallel port and the corresponding port on
the printer.
❑ During POST, press F2 to access the Setup Utility. Go to
the Advanced screen and verify that the parallel port is
enabled. See “Advanced” on page 86 for details.
I prefer using an external keyboard and mouse, but both
have PS/2 connectors and there is only one PS/2 port on the
computer.
To connect two PS/2-type devices to the computer, you
need to use a PS/2 Y-bridge connector. See “PS/2 Y-Bridge
Cable” on page 56 for details.
I want to set-up my location to use the internal modem.
To properly use your communications software (e.g.,
HyperTerminal), you need to set-up your location:
310-e.book Page 98 Tuesday, October 27, 1998 5:17 PM