Atlantis Land A02-AP1-W54 - Manual (Page 20)

Wireless Multi-Function Access Point
A02-AP1-W54 Pag. 13
3.2 Default Settings
Before configuring the Wireless AP through WLAN, make sure that the SSID,
Channel and the WEP was set properly.
The default setting of the Wireless AP that you will use:
ƒ
User: admin
ƒ Password: admin
ƒ IP Address: 192.168.1.1
ƒ Subnet Mask: 255.255.255.0
ƒ Wep Encryption: disable
ƒ SSSID: default
ƒ Channel:6
3.2.1 Password
When there is a screen needs to enter the Network password, it means that there
is a password settle, type in the password you entered before.
3.2.2 LAN WLAN
The parameters of LAN and WLAN ports are pre-set in the factory. The default
values are shown below.
LAN WLAN
IP address 192.168.1.1
Subnet Mask 255.255.255.0
Channel=6
SSID=default
Encryption=none
3.3 Accessing the Access Point Web Configurator
Before you configure this device, note that when the AP is configured through an
Ethernet connection, make sure the manager PC must be set on same the IP
network. For example, when the default network address of the default IP
address of the AP is 192.168.1.1, then the manager PC should be set at
192.168.1.x (where x is a number between 2 and 254), and the default subnet
mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter IP address http://192.168.1.1 (the factory-default IP address setting) to the
address location.