American Dryer Corp. MLG32PD3 - Manual (Page 29)

25
SECTION IV
OPERATING INSTRUCTIONS
A. STARTING THE DRYER
The dryer is available for use when the appropriate side of the microprocessor display reads “0 minutes” and the
amount needed to start the dryer (i.e., “25”). Once the load has been put into the dryer and the main door is
closed, start the dryer as follows:
1. Insert the proper number of coins into the coin acceptor. Once the correct “Amount To Start” has been
inserted, the display will read “SELECT CYCLE.”
2. Determine fabric setting (selection).
Once the fabric temperature setting (selection) has been determined, start the dryer by pressing the fabric
setting key.
3. The dryer will now start, and the display will read the setting and the time vended.
4. The cycle time will count down until the drying and cooling cycles are completed.
5. Upon completion of the drying cycle and cooling cycle, the dryer will shutoff.
a. Notes
1) The dryer basket (tumbler) can be stopped at any time by opening the main door. To restart
dryer, shut the main door and press desired setting.
NOTE: When a cycle is interrupted by opening the main door, cycle time will continue to count
downward, regardless if the door is open or closed.
2) Selection (setting) changes can be made at any time during the drying cycle.