Ultra Start 43xx - Manual (Page 8)

6 Pin Power Connector
6-pin Description Test For Wire
1-Yellow 30amp Starter Output - This wire will test 0volts in off, accessory and in
the ignition position.12volts during start only.
2-Green 30amp Heat/Acc Output - This wire will test 0volts in the off position 12-
14volts in the accessory and run positions and 0 volts during start
3-Red 30amp Power Input - 12volts at ignition harness or from battery. Supplies
power for the ignition, selectable output and park light relays.
4-Red 30amp Power Input - 12volt power at ignition harness or from battery.
Supplies power for accessory and start relays
5-Blue 30amp Ignition Output - This wire will test 0volts in the off and accessory
position 12volts in the ignition, start and run.
6-White 30amp Select Output - Selectable output for 2nd Ign, acc or starter.
Auxiliary Connectors - 4, 11 and 14 pin Connectors
Pin Number Function Description
1-Yellow Re-Arm Output- 0.75 second pulsed output when locked and on
remote start shutdown. Used for factory alarm re-arm.
Programmable output. See Menu 3
2-Red/Wht Trunk Release Output (-) - Hold the unlock button for 3 seconds.
Output will stay on until the unlock button is released (Max 5 seconds)
Programmable to (-)Park lights. See Menu 2
3-Brown Disarm Output (-) - 0.75sec pulsed output when unlocked and pulse
before remote start activation. Used for Factory Alarm Disarm.
4-Orange Starter Kill and Negative While Running Output (-) - Active when
armed and/or during remote start.
Anti-Grind - Used for optional starter disable, and anti-grind relay.
Programmable output. See Menu 3
5-White/ Blue Siren Output (+) - Output to activate siren.
Programmable output See Menu 1&2
6-Black/White Park Brake Input (-) - Input to detect Park Brake Switch.
Connect switch that provides (-) when the switch is applied.
7-Purple Door Pin Input (+) - Input to detect open door. Connect to door pin
that switches to 12volts when the door opened.
8-White Park Lights Output (+) - +10amp park light output. Connect to circuit
0volts when Parking Lights are off, 12volts when park lights are on.
9-Green/White Hood Pin Input (-) - Negative input from hood pin safety switch.
Switch is grounded when the hood is opened. Must be connected.
10-Green Door Pin Input (-) - Input to detect open door. Connect to door pin
that switches to Negative when the door is opened.
Page 8
INSTALLATION MANUAL
2WAY REMOTE STARTER/ALARM