Ultra Start 43xx - Manual (Page 17)

Menu 1- User Settings.. .
continued from previous page
Setting 6 Sensor Enable/Disable
1) Sensor Disabled
1 Flash/Chirp Impact Sensor Disabled
*2) Sensor Enabled 2 Flashes/Chirps Impact Sensor Enabled
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Passive/Active Arming
1) Passive Arming
1 Flash/chirp Auto Arms 30 seconds after last door is closed
2) Active Arming with Rearm 2 Flashes/chirps If unlock is pressed and no door is opened
*3) Active Arming 3 Flashes/chirps Arms with remote transmitter only
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 7 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/ siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Menu 2 - Additional Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #2 (Unlock)
Setting 1 Secure Valet Mode - Length of time required to set the system into Service Mode
1) Secure Valet
1 Flash/chirp Hold the Program Button for 15 seconds
*2) Normal Valet 2 Flashes/chirps Hold the Program Button for 5 seconds
Press & Release the Program Button 1 Time (Setting 1) confirmed 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirenchirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 Parking Light/Trunk Output (14 pin auxiliary connector pins 2&8)
1) 30 sec. Output
1 Flash/chirp Park Lights on for 30 seconds when Unlock is pressed
2) Negative Park Lights 2 Flashes/chirps Switches the Park Lights/Trunk Outputs
*3) Park Lights 3 Flashes/chirps 2 Park Light Flashes when Unlock is pressed
Press & Release the Program Button 2 Times (Setting 2) confirmed 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Horn chirp Timing (14 pin auxiliary connector pin 5)
1) 5 ms Pulse Output
1 Flash/chirp Short(Quiet) Horn Output Pulses
2) 15 ms Pulse Output 2 Flashes/chirps Long(Loud) Horn Output Pulses
*3) 10 ms Pulse Output 3 Flashes/chirps Normal(Medium) Horn Output Pulses
Press & Release the Program Button 3 Times (Setting 3) confirmed 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
*(Default Settings)
Page 17
2WAY REMOTE STARTER/ALARM
INSTALLATION MANUAL
Ignition 3x
On/Off
On/Off On Press and
Release
the Program
Button
Press button
2 to enter
Program
Menu 2
Press and
Release the
Program Switch
1x =Setting 1
2x =Setting 2
3x =Setting 3.... Press and
Hold the
Program Switch
1x = Option 1
2x = Option 2
3x = Option 3....
1 2 3
4