Ultra Start 43xx - Manual (Page 21)

Transmitter Programming
Step 1 - Within 3 seconds turn the ignition ON-OFF-ON-OFF-ON - Leaving Key ON
Step 2 - Press and hold the Program Button - The park lights will turn ON and the siren will chirp once.*
Continue to hold the Program Button, the park lights will turn off and the siren will chirp 5 times quickly.
Step 3 - While holding the Program Button, press the LOCK button on each of the remote’s to be programmed.
If remote’s are being programmed for 2nd Car Operation press the # button on each of the 2nd car
remote’s to be programmed.
Note: The park lights will flash once and the siren will chirp once each time a new code is learned.
Note: Transmitter programming must done quickly. Do not pause more than one second between each transmitter.
All the transmitters to be used must be programmed at the same time. All transmitters not programmed
at this time will be erased from memory for security. The system holds a maximum of 4 transmitter
codes including 2nd car remote codes.
*If the Park Lights do not turn ON, turn ignition OFF, wait 5 seconds and repeat steps 1&2
Page 21
2WAY REMOTE STARTER/ALAM
INSTALLATION MANUAL
When the Battery Icon on the remote indicates that the battery is low the
battery should be changed promptly. Replace with quality 1.5volt “AAA”
battery.
Battery Replacement
Ignition 3x
On/Off
On/Off On
Press and
HOLD the
Program
Button
Press and
Release
Button # 1 Press and
Release
Button # 1 Press and
Release
Button # 1 Press and
Release
Button # 1
1 2 3
4
1 2 3
4
1 2 3
4
1 2 3
4
1 2 3
4
Ba
tter
y
Slide
Ba
tter
y
Lift
Slide
Bt
a
ter
y
Positive
Negative