Spektrum SPMAR6260 User Manual
Page 17
17
EN
Problem
Possible Cause
Solution
The system will
not connect
Your transmitter and
receiver are too close
together. They should be
8 to 12 feet apart
Move transmitter 8 to 12
feet from receiver
You are around metal
objects
Move to an area with less
metal
Model selected is not the
model bound to
Check model selected and
ensure you are bound to
that model
Your transmitter was
accidentally put into bind
mode and is not bound
to your receiver anymore
Rebind your transmitter and
receiver
Receiver quits
responding
during operation
Inadequate battery
voltage
Charge batteries. Spektrum
receivers require at least
3.5V to operate. An
inadequate power supply
can allow voltage to
momentarily drop below
3.5V and cause the receiver
to brownout and reconnect
Loose or damaged wires
or connectors between
battery and receiver
Check the wires and
connection between
battery and receiver. Repair
or replace wires and/or
connectors
Receiver loses
its bind
Transmitter stand or tray
could be depressing the
bind button
If stand is depressing bind
button, remove from stand
and rebind
Bind button pressed
before transmitter
turned on
Rebind your system
following binding
instructions
Receiver blinking
at landing
System turned on and
connected, then receiver
turned off without turning
off transmitter
Turn off transmitter when
receiver is turned off