Spektrum SPMAS6410NBL - Manual (Page 7)

EN
7
Advanced Programming Features
NOTICE: To make these changes, enlist the use of a helper to either hold the
aircraft to prevent unintended fl yaways or to make the changes on the transmitter.
CAUTION: Make sure your receiver is off BEFORE making any advanced
programming changes in order to prevent the motor from arming.
The following programming features are only recommended for advanced radio
users. The photos in this section show the E-fl ite
® MLP4DSM transmitter; however,
the procedures apply to all compatible transmitters.
Computer Transmitters
Prior to making any advanced programming feature changes, it is necessary to:
1. Choose an empty model location.
2. Select model type ACRO.
3. Perform a model reset.
4. Set all channels to normal.
5. Ensure the transmitter and receiver are bound.
CAUTION: Secure the aircraft safely to a work bench or enlist the use of a
helper while accessing the advanced programming features. Mistakes in
programming could cause the motor to run unexpectedly, which could result in
injury or a crash.
Reversing Servos
Servo reversing is done through your transmitter’s servo reversing
function.
You may also reverse the actual servos by following the instructions below.
Reversing Linear Servos
Reversing the servo is useful when implementing certain
installations, such as dual ailerons, fl aps, etc. Spektrum
offers a servo reversing lead that you can plug in between
the receiver and the optional servo.
To reverse the servo using the reversing lead:
1. Plug the reversing lead into the servo
2. Plug the servo into the servo port(s)
3. Power the receiver using a charged battery
4. Once the receiver connects, the servo is now reversed
5. Disconnect the battery from the receiver
6. Remove the servo reversing lead (be sure to store
your reversing lead in a safe place for future use)
7. Reinstall the servo lead into the servo port(s)