Spektrum SPMAS6410NBL User Manual
Page 5
EN
5
Receiver Installation
We recommend using double-sided foam tape and/or minimal hot glue
in the corners to install your receiver in the fuselage. The servos must be
in the appropriate position to attach to and drive the elevator and rudder
pushrods.
The motor wires must be aligned parallel to the fuselage of the aircraft for
correct AS3X Stabilization.
CAUTION: If AS3X is active and the receiver is not installed correctly,
the aircraft will crash.
Servos
Specially designed servos are available from Spektrum.
NOTICE: Using any other servo(s) may cause damage to the receiver and/or
void the servo warranty.
AS6410NBL Features and Ports
Antenna
Rudder (CH4) Servo
Elevator (CH3) Servo
X-Port (all 4 pins)
OR
Gear (CH5) (3 pins to the left)
Reversed Aileron
(CH2) or Aux1 (CH6)
Battery Input
Aileron (CH2)
Brushless
Motor Leads
Do not install the receiver in the aircraft as shown.
Do Not install
with motor wires
parallel to the
wings
Do Not install
with motor wires
perpendicular
to the wings.