Binding – Spektrum SPMMS3132 User Manual

Page 10

Spektrum Air Module

1. With the system hooked up as shown, insert the bind plug in the

charge plug receptacle.

note: When binding using a switch harness, a 3-wire switch harness
must be used such as SPM9530.
note: to bind an aircraft with an electronic speed controller that powers
the receiver through the throttle channel (BEC), insert the bind plug into
the battery port and proceed to Step #2.

It’s necessary to program the receiver to the specific module so that the receiver
will only recognize that module, ignoring signals from any other sources. If the
receiver is not bound to the module, the system will not operate. During binding
the servo’s failsafe positions are stored.
The following sequence shows the binding procedure for the AR12000,
however, all Spektrum aircraft receivers are bound in the same way.
How to Bind
the AR12000 receiver must be bound to the module before it will operate.
Binding is the process of teaching the receiver the specific code of the transmitter
so it will connect to that specific module. Once bound, the receiver will only
connect to that module.

Binding

2. turn on the receiver switch. Note that the LEDs on all receivers should be

flashing, indicating that the receiver is ready to bind.

3. Establish the desired failsafe stick positions: normally low throttle and flight

controls neutral.

Binding