Spektrum SPMR2200 DX2M - Manual (Page 9)

EN
9
Safety points to Obey for Modelers
• Ensure your batteries (both transmitter and receiver) have been properly
charged for your model.
• Keep track of the time the system is turned on so you will know how long
you can safely operate your DX2M.
• Check all servos and their connections prior to each run.
• Do not operate your model near spectators, parking areas or any other area
that could result in injury to people or damage of property.
• Do not operate your model during adverse weather conditions. Poor
visibility can cause disorientation and loss of control of your model.
• Do not point the transmitter antenna directly toward the model.
The radiation pattern from the tip of the antenna is inherently low.
• Do not take chances. If at any time during the operation of your model you
observe any erratic or abnormal operation, immediately stop operation
of your model until the cause of the problem has been ascertained and
corrected. Safety can never be taken lightly.
problem possible Cause Solution
• The system will not connect
• Your transmitter and receiver are too close together.
They should be 1 to 4 feet apart.
• You are around metal objects.
• Your transmitter was accidentally put into bind mode
and is not bound to your receiver anymore.
• Move transmitter 1 to 4 feet from receiver.
• Move to an area with less metal.
• Rebind your transmitter and receiver.
• The receiver goes into failsafe mode
a short distance away from the
transmitter
• Check the receiver antenna to be sure it is not cut or
damaged.
• Replace SR3100 antenna (SPM9005) or contact Horizon
Product Support
• Make sure your antenna is in an antenna tube and up in
the air as high as possible
• Receiver quits responding during
operation
• Inadequate battery voltage
• Loose or damaged wires or connections between
battery and receiver
• Charge batteries. Spektrum receivers require at least 3.5V
to operate. An inadequate power supply can allow voltage
to momentarily drop below 3.5V and cause the receiver to
brown out and reconnect.
• Check the wires and connection between battery and
receiver. Repair or replace wires and/or connectors
DX2M Troubleshooting Guide