Spektrum SPM4000C DX4S - Manual (Page 17)

17 SPEKTRUM DX4S • TRANSMITTER INSTRUCTION MANUAL
EN
TROUBLESHOOTING GUIDE
Problem Possible Cause Solution
The system will
not connect Transmitter and receiver too near each other Move transmitter 8 to 12 feet (2.4 to 3.6m) from
receiver
Transmitter and receiver too near large metal
objects (vehicles, etc.) Move away from large metal objects (vehicles, etc.)
Selected model is not bound in transmitter Make sure correct model memory is selected and that
transmitter is bound to the model
Transmitter accidentally put in bind mode so
receiver is no longer bound Rebind transmitter and receiver
The receiver goes
into failsafe mode a
short distance away
from the transmitter Check the receiver antenna to be sure it is not
cut or damaged Replace or contact Horizon Product Support
Make sure receiver antenna is in an antenna tube and
is above vehicle
Receiver quits
responding during
operation Low battery voltage Completely recharge battery
Loose or damaged wires or connectors between
battery and receiver Do a check of the wires and connection between
battery and receiver. Repair or replace wires and/or
connectors
Receiver loses its
bind Transmitter accidentally put in bind mode, ending
bind to receiver Bind transmitter to receiver
Receiver taking
longer than usual to
link with transmitter Transmitter and receiver are operating on Marine
model Marine receivers can take longer to link with
transmitter
This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifi cations not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This product contains a radio transmitter with wireless technol-
ogy which has been tested and found to be compliant with
the applicable regulations governing a radio transmitter in the
2.400GHz to 2.4835GHz frequency range.
Antenna Separation Distance
When operating your Spektrum transmitter, please be sure to
maintain a separation distance of at least 5 cm between your
body (excluding fi ngers, hands, wrists, ankles and feet) and the
antenna to meet RF exposure safety requirements as determined
by FCC regulations.
The illustrations below show the approximate 5 cm RF exposure
area and typical hand placement when operating your Spektrum
transmitter.
FCC INFORMATION
Information de IC
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit ac-
cepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.