Blodgett CTBR - Manual (Page 14)

12
Operation
Solid State digital
Solid State
1
2
3
8
7
10
4
5
6
9
11
Figure 9
COMPOnEnT dESCRIPTIOn
1. SELECTOR SWITCH - turns power to the oven on
or off. Allows selection of Cook or Cool Down modes
and fan speed (if applicable).
2. DISPLAY - displays time, temperature, or other infor-
mation related to oven function.
3. HEAT LAMP - lights when heater is on.
4. PULSE LAMP - lights when Pulsed Fan Mode is
turned on.
5. HOLD LAMP - lights when Hold Mode is turned on.
6. DIAL - used to enter set points in display.
7. START/STOP KEY - starts or stops the timer.
8. TIME KEY - used to show time in the display.
9. TEMP KEY - used to show set temperature in the dis-
play.
NOTE: Actual temperature is shown while the TEMP
key is held down.
10. HOLD KEY - turns Hold Mode on or off.
11. PULSE KEY - turns Pulse Mode on or off.
PROGRaMMInG
To set the cook temperature:
1. Press the TEMP (9) key.
2. Rotate the dial (6) to enter the cook temperature.
To set the cook time:
1. Press the TIME (8) key.
2. Rotate the dial (6) to enter the cook time.
NOTE: Time is entered in hours : minutes or minutes
: seconds.
To set the hold time:
1. Press the HOLD key (10) to turn hold mode on.
NOTE: HOLD light is on.
2. Rotate the dial (6) to enter the hold temperature.
3. Press the START/STOP key (7)
To set the pulse time:
1. Press the PULSE KEY (11) to turn pulse mode on.
NOTE: Pulse light is on.
2. Rotate the DIAL (6) to enter the pulse time. Pulse
time is a portion of the pre-set cook time.