Allied Telesis AT-WG101 - Manual (Page 2)

| | |
Installing an AT-WG101 Diplexer
To install the AT-WG101 Diplexer, perform the following
procedure:
1. Remove the diplexer from the shipping package and store the
packaging material in a safe place.
2. Connect single mode fiber to single female SC connector.
3. Connect duplex male connector to the mating SC connector
(transceiver).
Allied Telesyn, Inc.
960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Tel 1 (408) 730-0950 • Fax 1 (408) 736-0100
Visit our web site at: www.alliedtelesyn.co m
Copyright  2003 Allied Telesyn Inc.
All rights reserved. No part of this publication may be reproduced without
prior written permission from Allied Telesyn, Inc.
Installing an AT-WG101 Diplexer
To install the AT-WG101 Diplexer, perform the following
procedure:
1. Remove the diplexer from the shipping package and store the
packaging material in a safe place.
2. Connect single mode fiber to single female SC connector.
3. Connect duplex male connector to the mating SC connector
(transceiver).
Allied Telesyn, Inc.
960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Tel 1 (408) 730-0950 • Fax 1 (408) 736-0100
Visit our web site at: www.alliedtelesyn.co m
Copyright  2003 Allied Telesyn Inc.
All rights reserved. No part of this publication may be reproduced without
prior written permission from Allied Telesyn, Inc.
Installing an AT-WG101 Diplexer
To install the AT-WG101 Diplexer, perform the following
procedure:
1. Remove the diplexer from the shipping package and store the
packaging material in a safe place.
2. Connect single mode fiber to single female SC connector.
3. Connect duplex male connector to the mating SC connector
(transceiver).
Allied Telesyn, Inc.
960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Tel 1 (408) 730-0950 • Fax 1 (408) 736-0100
Visit our web site at: www.alliedtelesyn.co m
Copyright  2003 Allied Telesyn Inc.
All rights reserved. No part of this publication may be reproduced without
prior written permission from Allied Telesyn, Inc.
Installing an AT-WG101 Diplexer
To install the AT-WG101 Diplexer, perform the following
procedure:
1. Remove the diplexer from the shipping package and store the
packaging material in a safe place.
2. Connect single mode fiber to single female SC connector.
3. Connect duplex male connector to the mating SC connector
(transceiver).
Allied Telesyn, Inc.
960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Tel 1 (408) 730-0950 • Fax 1 (408) 736-0100
Visit our web site at: www.alliedtelesyn.com
Copyright  2003 Allied Telesyn Inc.
All rights reserved. No part of this publication may be reproduced without
prior written permission from Allied Telesyn, Inc.