Allied Telesis AT-8201 - Manual (Page 3)

iii
Electrical Safety and
Installation Requirements
STANDARDS : This product meets the following standards
RFI Emission EN55022 Class A
WARNING : In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate measures.
Immunity EN50082-1
SAFETY
ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock, do not remove cover. No user-serviceable parts inside. This unit contains HAZARDOUS VOLTAGES and
should only be opened by a trained and qualified technician. To avoid the possibility of ELECTRIC SHOCK, disconnect electric power
to the product before connecting or disconnecting the LAN cables.
This is a “ CLASS 1 LED PRODUCT .”
LIGHTNING DANGER
DANGER
: DO NOT WORK on equipment or CABLES during periods of LIGHTNING ACTIVITY.
INSTALLATION
ELECTRICAL—AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the label.
ELECTRICAL—TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED.
Power plug must be connected to a properly wired earth ground socket outlet. An
improperly wired socket outlet could place hazardous voltages on accessible metal parts.
ELECTRICAL—CORD NOTICE
Use power cord, maximum 4.5 meters long, rated 6 amp minimum, 250V, made of HAR cordage molded IEC 320 connector on one end
and on the other end a plug approved by the country of end use.
CAUTION : Air vents must not be blocked and must have free access to the room ambient air for cooling.
CAUTION : DO NOT detach rubber feet from the product unless an Allied Telesyn vertical mounting chassis is being used.
OPERATING TEMPERATURE
This product is designed for a maximum ambient temperature of 40 ° C .
ALL COUNTRIES: Install product in accordance with local and National Electrical Codes.
U.S. Federal Communications Commission
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with this instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Note: Modifications or changes not expressly approved by the manufacturer or the FCC can void your right to operate this
equipment.
Canadian Department of Communications
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.