Allied Telesis AT-BSTACK1 - Manual (Page 11)

1
Overview
The AT-BSTACK1 Stacking Module is designed for the AT-8324SX Fast
Ethernet Switch. You use the module to create stacks of up to four switches.
Running at a bandwidth of over 4 Gbps, this module provides a common
interface to the attached switches, allowing the stack to function and be
managed as a single device.
Caution
The stacking module is designed for the AT-8324SX Fast Ethernet
Switch only. Do not install this module in any other Allied Telesyn
device.
Note
One AT-BSTACK1 module must be installed in each AT-8324SX switch
that will be a part of the stack.
For installation instructions for the AT-8324SX switch, refer to the AT-
8324SX Fast Ethernet Switch Installation Guide. For instructions on how to
manage a stack, refer to the AT-S29 Management Software User’s Guide. Both
of these guides are available from the Allied Telesyn web site.