Allied Telesis AT-GS908 - Manual (Page 30)

Installation
20
Installing the Switch in a Rack
To install the AT-GS908 in a standard 19-inch rack, perform the following
procedure:
1. If attached, remove the rubber feet by using a flat-head screwdriver
as shown in Figure 8.
Figure 8 Removing the Rubber Feet
2. Attach a bracket to one side of the switch using the bracketmounting
screws that came with the switch. See Figure 9.
Figure 9 Attaching Rackmounting Brackets
3. Install the second rackmounting bracket on the other side of the
switch using the remaining bracketmounting screws.
4. Mount the switch in the 19-inch rack using four rackmounting screws
(not provided).
5. Refer to Step 4 on page 18 in the previous section to complete the
installation.