Allied Telesis AT-VIEW PLUS 3.1 INSTALLATION - Manual (Page 8)

Allied Telesyn AT-VIEW PLUS 3.1
INSTALLATION GUIDE
If there is a previous installation of AT-View Plus on your machine, a message box will
open advising you to uninstall the application first before running the AT-View Plus 3.1
installer again. To uninstall AT-View Plus, refer to section 9 Uninstalling AT-View Plus
3.1 .
5. Specify the mode or type of installation, if you want to install AT-View Plus 3.1 with
SNMPc, OpenView, or NetView integration, or just the AT-View Plus 3.1 application
and/or documentation. The selection below will depend on which network
management system is installed on your computer.
This window will not be displayed if you have chosen to install the AT-View Plus 3.1
documentation only, if you do not have SNMPc, OpenView or NetView installed on your
computer, or if SNMPc or OpenView servic es are running or NetView services are not
running.
Select “NONE” if you want to install AT-View Plus 3.1 as a standalone application.
Click Next to continue.
If NetView integration is selected, the following message is displayed:
PN 613-50659-00 Rev B Page 8 of 26