Allied Telesis AT-8700XL SERIES - Manual (Page 3)

3
SAFETY AND STATUTORY INFORMATION
WARNING: As a safety precaution, a 10 Amp circuit breaker should be installed at the
supply end of the cable to be used with this LAN equipment.
ALWAYS connect the wiring to the LAN equipment first before connecting the wiring to
the breaker. To avoid the danger of physical injury from electrical shock, do not work with
HOT feeds. Always be sure that the breaker is in the OFF position before connecting the
wiring to the breaker.
WARNING: Do not strip more than the recommended amount of wire. Stripping more
than the recommended amount can create a safety hazard by leaving exposed wire on the
terminal block after installation.
WARNING: When installing this equipment, always ensure that the frame ground
connection is installed first and disconnected last.
WARNING: “Safety Hazard” - Check to see if there are any exposed copper
strands coming from the installed wires. When this installation is done correctly there
should be no exposed copper wire strands extending from the terminal block. Any
exposed wiring can conduct harmful levels of electricity to persons touching the wires.
DC versions of this system will work with a positive grounded or negative grounded DC
system.
ELECTRICAL - AC MAINS CIRCUIT OVERLOADING
When installing product, consideration must be given to the accumulative nameplate
ratings when connecting the equipment to the AC supply wiring.
CAUTION: MECHANICAL LOADING - Mounting of the equipment in the rack
should be such that a hazardous condition is not achieved due to uneven loading.
Lithium Battery - Should only be changed by trained and qualified technicians.
CAUTION: Danger of explosion if battery incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries
according to the manufacturer's instructions.
WARNUNG: Bei Verwendung zu Hause kann dieses Produkt Funkstörungen
hervorrufen. In diesem Fall müßte der Anwender angemessene Gegenmaßnahmen
ergreifen.
Normen: Dieses Produkt erfüllt die Anforderungen der nachfolgenden Normen.
SICHERHEIT
Elektrische Sicherheit: UL, cUL, CE, AS/NZS 3260.
WARNUNG Laserprodukt der Klasse 1.
WARNUNG Nicht direkt in den Strahl blicken.
ACHTUNG: GEFÄHRLICHE SPANNUNG
Das Gehäuse nicht öffnen. Das Gerät enthält keine vom Benutzer wartbaren Teile. Das
Gerät steht unter Hochspannung und darf nur von qualifiziertem technischem Personal
geöffnet werden. Vor Anschluß der LAN-Kabel, Gerät vom Netz trennen.