Allied Telesis AT-8700XL SERIES - Manual (Page 2)

2
AT-8700XL SERIES
WARNING: In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
Standards: This product meets the following safety standards.
SAFETY
Electrical Safety: UL, cUL, CE, AS/NZS 3260.
WARNING: Class 1 Laser product.
WARNING: Do not stare into the laser beam.
CAUTION: Use of controls or adjustments of performance or procedures other than
those specified herein may result in hazardous radiation exposure.
ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock , do not remove the cover. No user-serviceable parts inside.
This unit contains HAZARDOUS VOLTAGES and should only be opened by a trained
and qualified technician. To avoid the possibility of ELECTRIC SHOCK, disconnect
electric power to the product before connecting or disconnecting the LAN cables.
LIGHTNING DANGER
DANGER: DO NOT WORK on equipment or CABLES during periods of LIGHTNING
ACTIVITY.
CAUTION: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO DE-
ENERGIZE EQUIPMENT, disconnect the power cord.
ELECTRICAL - TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly
wired earth ground socket outlet. An improperly wired socket outlet could place
hazardous voltages on accessible metal parts.
PLUGGABLE EQUIPMENT, the socket outlet shall be installed near the equipment and
shall be easily accessible.
CAUTION: Air vents must not be blocked and must have free access to the room
ambient air for cooling.
OPERATING TEMPERATURE: This product is designed for a maximum ambient
temperature of 40° degrees C.
ALL COUNTRIES: Install product in accordance with local and National Electrical
Codes.
WARNING: For centralized DC power connection, install only in a restricted access
area.
A tray cable is required to connect the power source if the unit is powered by central-
ized DC power. The tray cable must be UL listed Type TC tray cable and rated at 600 V
and 90 degree C, with three conductors, minimum 14 AWG.
WARNING: Only trained and qualified personnel are allowed to install or replace this
equipment.