Allied Telesis SwitchBlade Chassis and Fan Tray - Manual (Page 6)

6 SwitchBlade Chassis and Fan Tray
C613-04029-01 REV C
Figure1: SwitchBlade rack crossbar.
5. Remove any packaging and protective material
Inside the chassis: Check that the internal spaces are free of packaging and
protective material.
Outside the chassis: Check that all vents are free from obstruction.
6. Insert the blank faceplates (if not factory fitted)
When inserting a faceplate, make sure the faceplate’s metal back-panel is
aligned with the card guides (see Figure 2 on page -6).
Faceplates are mounted vertically in the SwitchBlade 8 chassis (AT-SB4108) and
horizontally in the SwitchBlade 4 chassis (AT-SB4104).
Figure2: Card guides.
Carefully slide the faceplate into the chassis. The faceplate’s captive screws
should line up with the threaded holes on the chassis.
SwitchBlade Support Bar
bottom card guide