Allied Telesis AT-S63 - Manual (Page 19)

Starting a Management Session Guide
19
3. This command designates interface VLAN12-0 as the local interface
on the switch:
set ip local interface=vlan12-0
4. This command saves the changes to the switch’s active boot
configuration file:
save configuration
To remotely manage this enhanced stack, you would start the session by
specifying the master switch’s IP address at any remote management
workstation in the 149.22.88.0 subnet or from a workstation that has
access to the subnet through Layer 3 routing devices.
AT-9400 Basic
Layer 3 Stack
The steps for preparing a stack of AT-9400 Basic Layer 3 Switches and
the AT-StackXG Stacking Module for remote management are the same
as those for a stand-alone switch. The steps are:
1. Create a tagged or port-based VLAN of the ports where the remote
management workstations are members. You can use the
Default_VLAN for this purpose.
2. Assign a routing interface to the VLAN to act as the stack’s IP address.
3. If the remote management workstations are not members of the same
subnet as the stack, create a default gateway that defines the first hop
to reaching the workstations.
4. Designate the interface as the stack’s local interface so that the master
switch monitors the subnet for the management packets from the
remote management workstations.
This example assigns the IP address 149.124.82.14, subnet mask
255.255.255.0, and default gateway address 149.124.82.17 to a stack.
The VLAN for the remote management workstations will be called
Technical and will have the VID 2. The ports of the VLAN will consist of 1.4
to 1.6 on the master switch:
1. This command creates the Technical VLAN:
create vlan=Technical vid=2 untaggedports=1.4-1.6
2. This command adds the routing interface with the switch’s IP
configuration to the VLAN:
add ip interface=vlan2-0 ipaddress=149.124.82.14
mask=255.255.255.0
3. This command creates the default route:
add ip route=0.0.0.0 nexthop=149.124.82.17