Allied Telesis AlliedView-EMS 4.0 INSTALLATION - Manual (Page 3)

AlliedView™-EMS 4.0 INSTALLATION GUIDE Page 3 of 29
1 INTRODUCTION
This Installation Guide describes the installation, configuration, and registration procedures for
AlliedView-EMS 4.0 on Windows and UNIX. It also describes the system requirements for the
application. AlliedView-EMS comprises the Device Manager application for managing Allied Telesis
devices, the MIB browser AMIGO, the MIB Compiler, VLAN Manager and QoS Manager.
2 SYSTEM REQUIREMENTS
The following software and hardware components are required to run AlliedView-EMS 4.0. Make
sure that your system meets these requirements before installing AlliedView-EMS 4.0.
2.1 Windows
Hardware Pentium based PC, 64MB RAM (128MB+ recommended)
CPU Pentium 166MHz or greater (400MHz+ recommended)
Operating System 32-bit Windows: Windows 2000 (SP3 or later), Windows XP
(SP1 or later), Windows 2003
Video 1024 x 768 pixels, 64K or more colors
Supported NMS HP OpenView Network Node Manager v6.20 and v7.0; SNMPc
5.1.6c, 6.0, 7.0 and 7.1; Tivoli NetView 7.1.3; Ipswitch
WhatsUp Professional 2006
Hard Disk Space 120MB or greater (240MB or greater HDD space is temporarily
required during installation)
2.2 Solaris
Hardware SPARC station 20 or UltraSparc series (UltraSparc
recommended), 128MB RAM (256MB recommended)
Operating System Sun OS 5.8/Solaris 8 (32-bit version)
Video 64K or more colors
Supported NMS HP OpenView Network Node Manager v6.20 and v7.0
Hard Disk Space 145MB or greater (at least 15MB of SWAP area is required
during start-up; 275MB HDD space is temporarily required
during installation)
2.3 HP-UX
Hardware HP 9000 Workstations, HP Visualize Workstations, 128 MB
RAM (256 recommended)
Operating System HP-UX 11 (32-bit version)
Video 64K or more colors
Supported NMS HP OpenView Network Node Manager v6.20 and v7.0
Hard Disk Space 220MB or greater (at least 15MB of SWAP area is required
during start-up; 435MB HDD space is temporarily required
during installation)