Allied Telesis AT-S63 - Manual (Page 232)

Chapter 20: Internet Group Management Protocol Snooping Querier
232 Section III: Snooping Protocols
5. To confirm that IGMP snooping and IGMP snooping querier are
enabled on the switch and that the interface is functioning as the
querier:
show igmpsnooping
Figure 28. SHOW IGMPSNOOPING Command
6. To save the configuration:
save configuration
To configure the feature with the AlliedWare Plus commands:
1. To create the routing interface:
awplus> enable
awplus# configure terminal
awplus(config)# interface Default_VLAN
awplus(config-if)# ip address 149.123.48.2/24
awplus(config-if)# exit
IGMP Snooping Configuration:
IGMP Snooping Status ............... Enabled
Querier Admin ...................... Enabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect
Router List:
VLAN
Port/ Exp.
ID Trunk ID RouterIP Time
----------------------------------------------------
Host List:
Number of IGMP Multicast Groups: 0
VLAN Port/ IGMP Exp.
MulticastGroup ID TrunkID HostIP Ver Time
---------------------------------------------------------
VLAN Querier Interface Exp. Query Version 1
ID Status IP Address Time Version Source Port
-----------------------------------------------------------
1 Querier 149.123.48.2 78 Ver 2