Allied Telesis AT-9448Ts/XP (Basic Layer 3) User Manual
Installation guide, At-9400 series gigabit ethernet switches
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Preface
- Chapter 1
- Overview
- Descriptions
- 10/100/1000Base-T Twisted Pair Ports
- Fiber Optic Ports
- GBIC Transceiver Slots
- SFP Transceiver Slots
- XFP Transceiver Slots
- Redundant Twisted Pair Ports
- Compact Flash Card Slot
- Port LEDs
- System LEDs
- Stack LEDs
- Expansion Slot
- Terminal Port
- Power Over Ethernet
- AT-RPS3204 Redundant Power Supply
- AC Power Connector
- Overview
- Chapter 2
- Installing the Switch
- Reviewing Safety Precautions
- Selecting a Site
- Twisted Pair and Fiber Optic Cable Specifications
- Unpacking the Switch
- Installing the Power Cord Retaining Clip (AC Switches Only)
- Installing the Switch in a Rack
- Installing Optional Transceivers
- Cabling the Twisted Pair or Fiber Optic Ports
- Applying AC Power
- Starting a Local Management Session
- Warranty Registration
- Installing the Switch
- Chapter 3
- Troubleshooting
- Power LED is Off
- Twisted Pair Port Link LED is Off
- Fiber Optic Port Link LED is Off
- Transceiver is Installed but the Status is “Not Present”
- System Fault LED is Blinking
- System Fault LED is Steadily On
- PoE Device is Not Receiving Power
- Cannot Establish a Local (Out-of-Band) Management Session
- Switch Functions Intermittently
- Troubleshooting
- Appendix A