Allied Telesis AR750S-DP Secure VPN Router - Manual (Page 8)

Installation and Safety Guide
7
Installing the Router in a Rack
1. Check the rack.
• Ensure that the rack is safely secured and that it will not tip over. Devices
in a rack should be installed starting at the bottom, with the heavier
devices near the bottom of the rack.
• Ensure the rack has sufficient space for the router and its associated
cables. The router is 1U high.
2. Unscrew the feet from the router, if you have previously attached them.
3. Install cage nuts at the front of the rack so they are ready for the rack-mount
screws in the following steps.
4. Connect one bracket to each side of the router using the supplied screws
(see figure below).
5. Mount the router into the rack from the front, and tighten the 4 rack-mount
screws.
Two people are required at this point. One person can lift the router
into the rack and attach it to the front rails, while the second person safely
supports it from the rear.
Rmount