Allied Telesis AT-GS950/48PS - Manual (Page 39)

AT-GS950/48PS Switch Web Interface User’s Guide
39
User Interface Configuration
This procedure explains how to enable and disable the user interfaces on
the switch. With this procedure you can enable or disable the AT-GS950/
48PS SNMP Agent. For more information about SNMP, go to Chapter 16,
“SNMPv1 and v2c” on page 189 and Chapter 17, “SNMPv3” on page 201.
Note
The Web Server Status is displayed as Enabled for your
information only. The Web Server cannot be disabled.
SNMP Interface
To enable or disable the AT-GS950/48PS SNMP interface, perform the
following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select User Interface.
The User Interface Page is displayed. See Figure 10.
Figure 10. User Interface Page
3. Choose Enable or Disable from the pull down list for the SNMP Agent
parameter.
Enabled - When you enable this parameter, the SNMP agent is
active. You can manage the AT-GS950/48PS switch with Network
Management Software and the switch’s private MIB.
Disabled - When you enable this parameter, the SNMP agent is
inactive.
Note
See Chapter 16, “SNMPv1 and v2c” on page 189 and Chapter 17,
“SNMPv3” on page 201 to configure the remaining SNMP
parameters.