Audiovox Mobile Video VOD128A - Manual (Page 26)

26
ACCESSORIES
OVERHEAD DOME LIGHTS
The Dome Lights integrated into the VOD128A are controlled by a three position slide switch. Sliding the switch to the ON position will turn
the lights ON. The OFF position will prevent the lights from turning ON with the vehicle’s interior lighting, and the auto position will allow the
lights to turn ON and OFF with the vehicle’s interior lighting. Refer to the Installation Guide for wire connections. Do not leave the vehicle
unattended with the dome light switch in the ON position, as this could result in a discharged battery.
REMOTE SENSOR
The VOD128A incorporates two infrared remote sensors to relay signals to the unit when the remote control is pointed at the remote
WIRELESS HEADPHONES
WIRED HEADPHONES (OPTIONAL)
The VOD128A includes a built-in infrared transmitter for use with the supplied wireless headphones. The headphone volume is adjusted
using the controls on each headset. Any number of wireless headphones may be used but they must be used within a line of sight from the
transmitter, as infrared transmissions, like visible light travel only in a straight line. See the documentation accompanying your wireless
headphones.
Note: If the monitor is set to M2 mode, the headphones supplied with this unit will not work, as these headphones are single channel. Only
two-channel wireless headphones (Audiovox Model IR2CHS) will work with this unit when set to M2 mode. The only time it is necessary to
set this unit to M2 mode is if there is an RSA (Rear Seat Audio) installed in the vehicle or if two of these monitors are installed in one
vehicle.
There is one 1/8” headphone jack on the VOD128A that can be used with any standard wired stereo headphones with a 1/8” plug. This
jack is controlled by the volume up/down buttons on the VOD128A remote control or the +/- keys located on the unit.