Samsung PS58A676T1M - Manual (Page 4)

Troubleshooting
Before contacting the Samsung after-sales service, perform the following simple checks.
If you cannot solve the problem using the instructions below, note the model and serial number of the television and contact your local dealer.
No sound or picture • Check that the mains lead has been connected to a wall socket.
• Check that you have pressed the (Power) button (On/Off) on the front panel or press the
POWER button on the remote control.
• Check the picture contrast and brightness settings.
• Check the volume.
• Check if TV Speaker is set to Off.
Normal picture but no sound • Check the volume.
• Check whether the volume MUTE button on the remote control has been pressed.
No picture or black and white
picture
• Adjust the colour settings.
• Check that the broadcast system selected is correct.
Sound and picture
interference
• Try to identify the electrical appliance that is affecting the television, then move it further away.
• Plug the television into a different main socket.
Blurred or snowy picture,
distorted sound
• Check the direction, location and connections of your aerial.
This interference often occurs due to the use of an indoor aerial.
Remote control malfunctions • Replace the remote control batteries.
• Clean the upper edge of the remote control (transmission window).
• Check that the “+” and “–” ends of the batteries are inserted correctly.
• Check that the batteries are drained.
Screen is black and power
indicator light blinks steadily
• On your computer check; Power, Signal Cable.
• The TV is using its power management system.
• Move the computer’s mouse or press any key on the keyboard.
• On your equipment check (STB, DVD, etc) ; Power, Signal Cable.
• The TV is using its power management system.
• Press the Source button on the panel or remote control.
• Turn the TV off and on.
The damaged picture appears
in the corner of the screen.
• If Just Scan is selected in some external devices, the damaged picture may appear in the
corner of the screen. This symptom is caused by external devices, not TV.
The “Resets all settings to
the default values” message
appears.
• This appears when you press and hold the EXIT button for a while. The product settings are
reset to the factory defaults.
Storing Channels Automatically
1. Press the MENU button to display the menu.
2. Press the ▲ or ▼ button to select Channel, then press the ENTER button.
. Press the ▲ or ▼ button to select Auto Store, then press the ENTER button.
4. Press the ▲ or ▼ button to select the channel source to memorize. Press the ENTER
button to select Start.
➢ Digital & Analogue: Digital and Analogue channels.
Digital: Digital channels.
Analogue: Analogue channels.
➢ Scans for all channels with active broadcast stations and stores them in the TV’s
memory.
➢ If you want to stop Auto Store, press the ENTER button. The Stop Auto Store?
message will be displayed. Select Yes by pressing the ◄ or ► button, then press
the ENTER button.
5. Press the EXIT button to exit.
➢ When there is a locked channel by Channel Lock setting, PIN input screen appears. (refer to page 25 of owner's manual)
Channel
Auto Store ►
Manual Store
Full Guide
Mini Guide
Default Guide
: Mini Guide
Channel List
Channel Mode
: Added Channels
Child Lock : On
Topaz F59A_QSG(CMS)-Eng.indd 3 2008-08-14 오전 11:09:43