Samsung RR35H6000SS - Manual (Page 13)

English - 13
SETTING
UP
REVERSING THE REFRIGERATOR
DOOR
Samsung recommends that reversing of
the door opening is only completed by
Samsung approved Service providers.
This will be on a chargeable basis and at
the customers expense.
Any damage caused while attempting to
reverse the door opening is not covered
under the appliance manufactures
warranty.
Any repairs requested due to this
circumstance will be completed on
a chargeable basis at the customers
expense.
Required Tools (Not provided)
Phillips Head
Driver (+)
Flat Head Driver
(-)
10 mm Socket
Wrench
(for bolts)
8 mm Socket
Wrench
(for bolts)
Spanner
(for hinge shaft)
5 mm Hex
Wrench
(for bottom hinge
shaft)
1. Remove 4 screws on the top of the refrigerator.
WARNING
2. Remove the plastic cover and make sure to
disconnect the wire connected to it.
After removing the plastic cover, check the
parts for reversing the door.
Be careful not to damage the electrical
wires when removing the plastic cover.
3. Disconnect the wires and then remove 3 bolts.
Make sure your refrigerator is unplugged
before handling electrical wires.
4. Remove the door from the lower hinge by
carefully lifting the door straight up.
Refrigerator door is heavy, be careful
not to injure yourself when removing the
refrigerator door.
CAUTION
WARNING
WARNING
DA68-03008E-01.indb 13 14. 4. 11. �� 10:40